The mask was purchased from a supplier of Venetian masks and adapted: the
sensors were installed in the end of the beak with a cable running back up to
the side of the face and down underneath the cloak to the computer: the sensor
unit is attached to the mask with velcro: a plastic seal was fitted into the
beak to close off the end of the beak from the performer's breath (it was made
from a plastic bag and some adhesive velcro): new airholes were drilled above
the seal: a stronger elastic headstrap was attached to the mask.
Figure 6.1:
The Snout
|
![\includegraphics[width=0.8\textwidth]{images/01_Mask.eps}](img22.png) |
Figure 6.2:
Mask Interior
|
![\includegraphics[width=0.8\textwidth]{images/02_Maskinterior.eps}](img23.png) |
Jenson Taylor
2008-01-25
